Each saw blade submitted for sharpening begins with testing and inspection on our state-of-the-art equipment to determine what work is required. From there it may go to have teeth replaced, to our welding facility, our flattening and tensioning equipment and always on to one of our grinders specially designed to make every tooth identical resulting in a perfectly balanced, razor sharp saw blade.
Testing & Inspection
The first step a blade goes through when you send it for sharpening is a complete inspection and testing to determine what work is required.
The photo at right shows a carbide tipped blade being tested for run out and tension. The graph drawn by this machine is used to hammer, flatten and tension the blade if necessary.
Hammering & Tensioning
During the testing process, a blade may need to be hammered flat and in some cases, roll tensioned to return stiffness to the blade so it will cut straight. These procedures are accomplished by our in-house personnel.
Sharpening
Almost every shop has the ability to touch up a slightly dulled blade. Specialty Saw's equipment is specifically designed to manufacture as well as sharpen your blades to accurate specifications. This means that every tooth will be exactly the same as the previous one which is the way to keep your blades balanced and cutting properly. Give us your test blade for a 100% guaranteed trial order resharpening. If you are not satified, for any reason, the work will be no charge.
1-800-225-0772 Specialty Saw, Inc.
30 Wolcott Road, Simsbury, CT 06070 USA
Voice: (860) 658-4419 ~ Fax: (860) 651-5358
